The Compleat Sculptor
" You supply the talent, we'll supply the rest!" Since 1995
Mold Making Compound Index & Mold Making and Casting Accessories & Casting Materials

SuperSeal™-Sealing Agent
Click Here to Order...
Super Seal was developed as an economical, fast drying sealant agent for a variety of surfaced including modeling clays, gypsum plasters, concrete and wood. THe sealing agent will quickly and effectively seal surfaced without interfering with the surface detail. Mold rubber (polyurethane, silicone pr Polysulfides) can then be applied. Click here for MSDS.
The Advantages of Using SuperSeal
  • Low Cost
  • Low Viscosity - wets out well over any surface
  • Evaporates Quickly
  • Ultra Thin Film - does not interfere with reproduction of surface detail or finish. Gives cured rubber mold surface a smooth, satin finish.
  • Removable - can be rinsed from model surface with warm water.
Directions - Applying SuperSeal
A minimum of 2 coats of SuperSeal is recommended to seal most surfaced. For extremely porous surfaces (ie. Limestone) and additional coat of SuperSeal may be required. Or apply two coats of SuperSeal and follow with an application of Universal Mold Release Agent.
SuperSeal can be applies using a soft brush or a non-aerosol spray bottle to lightly mist SuperSeal onto model.
  1. Apply a thorough coating of SuperSeal over entire model surface ad surrounding forms including intricate detail and undercuts. Compressed air or a hair dryer may be used to blow off any excess that has pooled. Let dry for 5 minutes.
  2. Repeat above 1 -2 more times and let final coat dry for at least 2 hours.
  3. If recommended by mold rubber manufacturer, apply a light mist coating of release agent (i.e Universal Mold Release).
IMPORTANT: Discoloration of model surface may occur. If compatibility between SuperSeal and model surface or SuperSeal and a particular mold rubber, a small scale teat should be made on an identical surface.

SAFETY FIRST

The material safety data sheet (MSDS) for this or any other Smooth-On product should be read prior to use and is available upon request from Smooth-On.  All Smooth-On products are safe to use if directions are read and followed carefully.

Be careful.  CONTENTS FLAMMABLE. Keep product away from heat, sparks, or open flame.  Do not puncture, or incinerate container.  Do not expose to heat or store at temperatures above 120F/48C. Use only with adequate ventilation. Contains Naphtha CAS# 64742-48-9

First Aid:   IF SWALLOWED, do not induce vomiting. Call Physician immediately.  If overcome by vapors, remove person from contaminated area.  FOR EYE CONTACT Immediately flush with plenty of water for at least 15 minutes. Get immediate medical attention.  FOR SKIN CONTACT.  Immediately flush with plenty of water. Remove contaminated clothing and footwear. Wash thoroughly with warm soapy water. Get medical attention if irritation persist. Use only as directed. KEEP OUT OF REACH OF CHILDREN.
Important: The information contained in this bulletin is considered accurate. However, no warranty is expressed or implied regarding the accuracy of the data, the results to be obtained from the use thereof, or that any such use will not infringe upon a patent. User shall determine the suitability of the product for the intended application and assume all risk and liability whatsoever in connection therewith.
Call for Technical Help:  (212) 367-7561
- back -

Although we try to keep the most updated prices on our website, all prices are subject to change.
1-800-9-SCULPT