The Compleat Sculptor
" You supply the talent, we'll supply the rest!" Since 1995

Jiffy Mixers

Jiffy Mixer model LM
LM		 Jiffy Mixer model HS
HS		 Jiffy Mixer model ES
ES		 Jiffy Mixer model PS
PS		 Jiffy Mixer model HD
HD


click here to order.

 

Model Shaft Length
in.       mm		 Container Size Top Diameter
in.        mm		 Bottom Dia.
in.         mm		 Depth of Head
in.          mm		 Shaft Dia.
in.         mm

    LM
      HS-1
      HS-2
      HS-3
      ES
      PS-1
      PS-2
      HD

10 1/4      260
10 1/4      260
14 3/4      375
30            762
20 1/2      521
20 1/2      521
40          1016
40          1016		 pint
1-2 gal.
1-2 gal.
1-2 gal.
2-5 gal.
5-10 gal.
10-50 gal.
75-100 gal.		 1 1/4        32
2 5/8        67
2 5/8        67
2 5/8        67
3 1/4        83
4 5/8      117
4 5/8      117
8 1/2      216		 1 1/4        32
2 5/8        67
2 5/8        67
2 5/8        67
3 3/4        95
5 1/8      130
5 1/8      130
9 3/4      248		 1 3/8       35
2 3/8       60
2 3/8       60
2 3/8       60
3 3/4       95
5           127
5           127
10         254		 1/4           6
1/4           6
1/4           6
1/4           6
3/8         10
1/2         13
1/2         13
3/4         19

 

Instructions for Mixer
READ COMPLETELY BEFORE USING

1. Tighten power tool chuck onto drive shaft of mixer.

2. The mixer MUST BE FULLY IMMERSED in material to be mixed before turning on the power tool, and MUST BE KEPT FULLY IMMERSED WHILE IN MOTION.

3. Hold power tool and mixer firmly. The container in which mixing is to be done should be secure so that it will not be thrown, spilling contents.

4. PREPARED, PACKAGED STOCK-TYPE materials, such as powders or pigments used in  formulation, can produce a sticky mass on the bottom of the container which must be loosened and dispersed. SUBMERGE mixer to within approximately 1in. of bottom of container. Turn on power and move mixer around bottom area until settled material has been brought into the mixture. Slowly move the mixer up and down and around in the material until contents are thoroughly mixed into a smooth, uniform body.

For powders, immerse mixer into fluid, start motor, slowly add powder into swirl around drive shaft above head of mixer.

5. CLEAN mixer after each use. Simply immerse in compatible solvent or water and run until clean. When cleaning solution is flammable, be sure to remove mixer from the power tool. Food service operators can put smaller mixers in their dishwashers.

6. NEVER RUN MIXER OUTSIDE OF THE MIXING OR CLEANING CONTAINER. 

DO NOT EXCEED RPMS FOR MODELS AS LISTED

MODEL              RPM MODEL               RPM
LM         up to     1200
HS-1      up to     1200
HS-2      up to     1200
HS-3      up to       800		 ES         up to     1000
PS-1      up to       800
PS-2      up to       450
HD         up to       250

Although we try to keep the most updated prices on our website, all prices are subject to change.
1-800-9-SCULPT