|
Weldbond As a Glue |
| Ready for use straight from the container. |
|
| DRYING TIME. Weldbond becomes tacky quickly and will dry within
the hour, depending on temperature and humidity. Weldbond is fully
cured when the bond is clear (transparent). The longer it’s
left, the stronger the bond. |
|
| SURFACE PREPARATIONS: Ensure all surfaces are clean and free from
dirt, oil and rust. |
|
| ANY POROUS TO NON-POROUS APPLICATION (i.e. WOOD TO METAL): Spread
thin film on both surfaces. Leave open for 1 or 2 minutes to become
tacky and slightly transparent, then squeeze both surfaces together
with slight turning motion. The longer this is left to cure the stronger
the bond. |
|
| ANY TWO NON-POROUS SURFACES (i.e. GLASS TO GLASS): Spread thin film
on both surfaces. Leave open for 2-3 minutes, then squeeze surfaces
together with a slightly turning motion. The longer this is left to
cure the stronger the bond. When cured the bond is clear (transparent).
A high temperature and low humidity speeds curing. |
|
| ANY TWO POROUS SURFACES (i.e. CHINA, POTTERY, CERAMICS): Best results:
Use a sealing mixture of 5 parts water 1 part Weldbond. First seal
both surfaces with this mixture, allow to dry (approx. 1 hr.) then
spread thin film of concentrated Weldbond over both surfaces and clamp
lightly or tape until fully cured. |
|
| * EXCEPTIONS: Some types of plastic, rubber and cast metals, i.e.
polyethylene, unbacked vinyl, p.v.c. and teflon.** NON-TOXIC as defined
in the Federal Hazardous Substances Act. |
|
| WORKING TEMPERATURE: For maximum performance use at temperatures
above 50ºF or 10ºC and on surfaces below 200ºF or 92ºC.
Protect contents from freezing. |
|
| NOTE: Do not use when bonding containers designed for use with or
subject to hot liquids. |
|
|
Weldbond As
a Sealer |
| Use as a porous surface sealing agent. Cut with 5 parts water to
1 part Weldbond and apply with roller, sponge or brush. For use on
untreated concrete, drywall, brick, block and mortar joints. Dries
to a clear non slip matte finish. Diluted with 5 parts water covers
up to 2000 sq.ft. at approx. 6¢ per sq.ft. Undiluted coverage
at 400 sq.ft. |
|
|
Weldbond
As a Bonding Agent |
| For cement, plaster and similar texture finishes. Ensure substrate
is clean and ready to accept the mix. Etch with chemical or mechanical
means where required. If surface is porous seal with the above sealing
mixture and allow to dry. Mix 3 parts Weldbond to 1 part water and
apply to surface, pour your intended mix over the wet down solution.
Weldbond is formulated for above grade applications only. |
|
|
For More Information: |
|
|